At only 3/16'' thick this heat shield withstands up to 1750 degrees F of direct continuous heat. The 12'' x 21'' sheet of heat shield is adhesive backed and flexes and adheres to bodywork very well.
Write Review
-
Heat shield
Great fit for the belly pan!
-
Better than Most
I like the Woodcraft/Armour Bodies Heat Barrier as it has an actual thin piece of metal to reflect heat and a Fiberglass thermal barrier to keep most heat from transferring thru to the belly pan close to Exhaust system, thin foil type aluminized fiberglass will eventually heat soak and will cause belly pan to become brittle after so many heat cycles
-
Frank Guadagnino
The sheet is semi-ridged, with a nice Aluminum face on it. Definetly a quality piece!
-
A little thick but works great
Used for the underside of the gas tank to replace a degraded original heat shield. This one is thicker and you will need good sears to cut to shape. Worked great.
-
Good Quality
Easy to trim, super sticky. I see this holding up for a long time on my R6 Track Bike.
-
Good stuff
fine quality heat shield
-
Awesome very sticky
Very very good As advertised. I only needed about 1/3 of the total material for my 07 r6 with a fiberglass race body. one tip., if the inside of your fiberglass race body is very rough, sand it down some to make the adhesive surface better.
-
Heat Shield
Easy to trim to fit...adhesive great.
- Availability:
- STG Part Number:
- A|W71-8099|0
- Manufacturer's Part Number:
- 1
