Billet aluminium alloy mechanical lever.
The billet machining, which uses sophisticated numerically controlled equipment, provides maximum lightweight values thanks to optimum machining tolerances and a higher general product quality, both intrinsically and aesthetically.
This lever is designed for riders with a radial brake master cylinder and mechanical clutch installed. Beyond the aesthetic reasons, this lever guarantees perfect sliding on the rotation pin.
TECHNICAL FEATURES
- Material: Billet aluminium
- Surface protection: Hard anodized
- Weight (gr): 130
- Note: Use with original braket
Write Review
-
Great Upgrade
This is a great product. It not only looks way better than the cheap OEM lever most bikes come with, it actually is better. It folds to stop it from breaking off in the event of a tip over, it's wider and more square across the face to improve control, and it's beautifully machined out of a block of aluminum. Basically, it works better, and looks better, especially if using a Brembo master cylinder on the other side.
-
Solid lever
Bought this lever to match the rcs19 corta corsa brake master cylinder lever. Visually it looks good but it is a little thicker. I should have done more research.
- Availability:
- STG Part Number:
- B|1200-110B01285|1
- Manufacturer's Part Number:
- 8
