Fresh air injected into the exhaust system on modified sportbikes can cause back pressure in the headpipes and muffler due to unburnt fuel from modified fuel mapping combined with additional oxygen spontaneously combusting in a high heat environment. Our blockoff plates will stop the annoying and possibly damaging back pressure from occurring while allowing you to remove a few pounds in associated valves and hoses fromyour bike. On late model EFI bikes with 02 sensors, ESPECIALLY when using Dynojet's Power Commander V with the Autotune feature, the air injection system MUST be blocked as it will introduce additional oxygen into the system which will skew your 02 sensor's values and make it impossible to get a correct tune.
Features:
- Driven Racing's emissions system block-o plates allow you to eliminate fresh air injection into your exhaust system with a simple to install, attractive package.
- Available for all late model sportbikes.
- Machined from 6061 Billet aluminum and then anodized black
- Kit comes complete with a cap for airbox.
- Note: Images shown are generic, each kit is designed according to spec for the application.
- Made in the USA
Important Emissions Notice to All Customers especially those in California
The State of California prohibits the offer for sale, sale, or installation of an aftermarket part, which alters or modifies the original design or performance of a motor vehicle's pollution control devices or systems, unless the aftermarket part has first been exempted from the state's anti-tampering laws and been issued an Executive Order (EO) number by the California Air Resource Board (ARB). Legal in California only for racing vehicles which may never be used, or registered or Licensed for use, upon a highway. Any California Residents (or residents of other US States) who order this part from Sportbike Track Gear llc agree they are doing so with the intention of using it on a closed course as outlined within the California Notice.
Important Emissions Notice to All Customers especially those in California
For race track use only, NOT LEGAL for street use.
Write Review
-
2015 cbr1000rr driven block off plates
Arrived earlier than expected, perfect fit and quality product.
-
Well made, perfect fit
Simple to install and seems to be well made. Fitment was perfect. Still re-building my CBR1000RR so I haven't been able to run it yet, but I expect it to work just fine.
-
Fits perfectly
Great product, fits perfectly, the cap was a little hard to get on but bike runs amazingly.
-
Easy, clean install.
I needed to get my Cbr on a dynometer after I installed an exhaust and power commander and I wanted a permanent fix to the pair valve throwing off the readings. This lil kit did the trick. 1.5 hour install and a quality product.
-
Driven blockoff plates
Excellent product, would highly recommend, excellent service from STG, shipped quickly to the UK and would use again for any other parts.
-
Excellent Quality
Bought these plates last week and love the quality and the finish on them. Great product and highly recommended for Honda CBR riders.
- Availability:
- STG Part Number:
- D|1405-DSBLOCK-4|1
- Manufacturer's Part Number:
- 1
