Fresh air injected into the exhaust system on modified sportbikes can cause back pressure in the headpipes and muffler due to unburnt fuel from modified fuel mapping combined with additional oxygen spontaneously combusting in a high heat environment. Our blockoff plates will stop the annoying and possibly damaging back pressure from occurring while allowing you to remove a few pounds in associated valves and hoses fromyour bike. On late model EFI bikes with 02 sensors, ESPECIALLY when using Dynojet's Power Commander V with the Autotune feature, the air injection system MUST be blocked as it will introduce additional oxygen into the system which will skew your 02 sensor's values and make it impossible to get a correct tune.
Features:
- Driven Racing's emissions system block-o plates allow you to eliminate fresh air injection into your exhaust system with a simple to install, attractive package.
- Available for all late model sportbikes.
- Machined from 6061 Billet aluminum and then anodized black
- Kit comes complete with a cap for airbox.
- Note: Images shown are generic, each kit is designed according to spec for the application.
- Made in the USA
Important Emissions Notice to All Customers especially those in California
The State of California prohibits the offer for sale, sale, or installation of an aftermarket part, which alters or modifies the original design or performance of a motor vehicle's pollution control devices or systems, unless the aftermarket part has first been exempted from the state's anti-tampering laws and been issued an Executive Order (EO) number by the California Air Resource Board (ARB). Legal in California only for racing vehicles which may never be used, or registered or Licensed for use, upon a highway. Any California Residents (or residents of other US States) who order this part from Sportbike Track Gear llc agree they are doing so with the intention of using it on a closed course as outlined within the California Notice.
Important Emissions Notice to All Customers especially those in California
For race track use only, NOT LEGAL for street use.
Write Review
-
DRIVEN BLOCK OFF PLATES SUZUKI GSX-R1000 17-19
2 Beards and Brian's video will get these plates installed on your GSXR1000. You will have your bike stripped down for this install, but it will be worth your while if you are installing a full exhaust system and flashing your ECU. I recommend the FTECU BikeSide Harness for this. I have a review of it on the 2017 Suzuki GSXR1000 product page. This was an easy install once all the components were removed and I also installed my Power Commander V at the same time...made it a lot easier with the air box off. Two nice pieces that have been powder coated and the fit was spot on. AAA+
-
Good quality
I don't give the 5 stars no because is not a good investment and good parts but I think the company needs to and in the package a set the screws, the originals is to long and you need to get shorers otherwise you gone damage the tread inside carefully.
-
Excellent product
Just what I required for my ECU flash
- Availability:
- STG Part Number:
- D|1405-DSBLOCK-1|3
- Manufacturer's Part Number:
- 2
