With this kit and your flashed ECU you can up-shift without letting off the throttle or pulling the clutch! This kit includes everything you will need to utilize your FTECU-flashed ECU’s Quickshifter Input. New dual sensors are now smaller and more reliable than ever! Manufactured by us here in the USA! Requires a bike side or bench tuning FTEcu flashing kit to activate the shifting within the tune.
Note: Shift sensor connector with Red wire is for PUSH switch, shift sensor connector with Black wire is for PULL switch. This means they eliminate the need to buy a specific push or pull sensor as these can be wired for either!
This kit includes:
- QS sensor (Dual contact: push/pull)
- Rod kit for your bike (cutting may be required to fit)
- Harness to interface to your ECU.
IMPORTANT NOTE: Due to the manner in which FlashTune licenses their products, all FlashTune items are ineligible for return. STG is here to support you after the sale in the unlikely event you have any issues. Please be sure of what you are ordering prior to placing your order, and don't hesitate to reach out to our team with any questions.
Write Review
-
Flash Tune Quickshifter
Was a breeze to install. Upgrading the factory kqs module. The FTQS is precise and really smoothed out the quick shifter response. Should have upgraded to this a very long time ago. Using it in standard shift setup with factory rear sets.
- Availability:
- STG Part Number:
- F|1500-FT-QSJ15_CH|0
- Manufacturer's Part Number:
- 8
