- Required for installation of Revolver and Rev 2 Throttle Kit on bikes with ignition and starter switches in stock throttle assembly
- Fits 7/8" bars (22.2mm)
- Extra-narrow design is only 26mm wide
- Push In/ Out engine switch
- Momentary 2-pole starter switch
- Starter switch has two separate circuits, one normally open, one normally closed for street bikes that use a headlight/ starter cutoff
- 550mm long wiring harness with brake light switch circuit wiring
- Brake light circuit wiring pigtail 120mm long with female spade connectors
- Stainless steel screws and internal rubber pad positions switch on handlebar securely without drilling holes
- Wiring harness has bare, tinned wires without connector for easy installation of OE connector body
- Made in Italy by Domino
Write Review
-
Start stop switch
Looks quality, Italian made. Have yet to install as loom is color coded but no schematic was included to locate correct wire. Some searching around might turn up something. Would have been nice to have. Otherwise product would be full on.
- Availability:
- STG Part Number:
- M|1864-11-0098|1
- Manufacturer's Part Number:
- 1
Other Details
Department
Handlebars and Grips
Manufacturer
Universal
Product
Switch
