- Designed to make suspension service simple and quick
- Holds shocks and forks securely while you change oil, re-valve, or change seals
- Pivoting head holds parts in any position, with mechanical stops every 45 degrees
- Aluminum Soft Jaw Vise holds cylindrically shaped parts utilizing a 4 point grip system
- Large side holds 39 mm to 69 mm diameter parts
- Small side holds 14 mm to 39 mm diameter parts
- Steel Frame is rigid yet has a small footprint, with 4 pre-drilled holes in the base for secure mounting to a bench
- Movable fluid catch pan with mesh insert, and threaded drain bung
HOW IT WORKS ON FORKS:
- Soft Jaw Fork Peg holds fork slider up for removal of dust seal and seal retaining clip
- Repositionable bottom slide bar holds forks compressed while bleeding air (priming cartridge) during reassembly and is an excellent platform for adding, adjusting and taking fork oil level measurements
- Can be used to assist in removing compression valve assembly (use of stock front axle required)
HOW IT WORKS ON SHOCKS:
- Holds shock firmly around shock body, shaft or shock reservoir
- Facilitates removal of piston rod and seal head
- Facilitates removal of shock reservoir caps, chamber pistons or bladder
- Holds shock to remove spherical bearings or needle bearings
- Holds shocks for removal of shock spring
Write Review
-
Motion Pro Pivot Suspension Vise
Typical high quality that I would expect from Motion Pro. My only compaint is the black drain pan is NOT what I recieved, I got an aluminum pan that has a sloppy fit over the pins on the mounting base. I'm sure it will work fine, But just not what was shown in the picture.
- Availability:
- STG Part Number:
- M|1864-08-0628|0
- Manufacturer's Part Number:
Other Details
